Transmission oil dipstick is located on the right side of the
transmission, the end of the dipstick marked with oil level
cold, hot mark line, to meet the oil level test conditions,
screw out the dipstick
and clean, then the dipstick into the transmission down in
place, remove Dipstick to observe the level of the dipstick is
qualified, as needed to add or discharge oil.
Detailed steps to detect oil level:
When it is not possible to determine if there is sufficient oil
in the transmission, do not start the engine. In this case, it
should be tested coldly, that is, the oil level should be
checked by using the dipstick only if the above conditions
are met. If the oil level in the cold under the lowest oil level
should be added to the cold minimum oil level, and then start
the engine idle for a minute, hang forward block D, and then
hang down the block R to discharge the air in the oil. After
the completion of the screw out of the dipstick and wipe
clean, then the dipstick into the transmission down to install
in place, remove the dipstick to observethe dipstick level line
in the cold and the lowest oil level between the lowest oil
level, if the cold The minimum oil level, the need to increase
the oil to the cold below the minimum oil level; if the lowest
in the hot state above, need to drain to the hot minimum
below the oil
level.
start the engine to continue idling operation, when the
transmission oil temperature at 65-75 ° C can be hot
To Next Page
Loading...
