detection. The appropriate oil level line is between the lowest
oil level and the highest hot oil level. If the oil level is lower
than the minimum oil level, need to increase the oil to the hot
minimum oil level above; if the oil level is higher than the
hot state of the highest oil level, need to drain to the hot state
below the maximum oil level.
The selector checks the oil level measurements to be
regularly compared to the dipstick measurements to ensure
numerical reliability.
Check the oil level should be carried out at least twice, the
oil level test results must be consistent or similar.
△
! Note: In the extraction of dipstick
should pay attention to the end down to prevent
oil back, and then plug the gear into the
transmission should be clean to prevent oil
contamination.
△
! Caution: Hot oil or hot parts may cause
injury when inspected, so do not let hot oil
or parts come into contact with skin.
The oil level of the transmission will rise with the oil
temperature rise. If the transmission fluid temperature is
lower than the normal operating temperature, do not fill the
oil above the above requirements. During the course of the
work, the oil is full and will not only cause energy loss, but
also make the transmission overheating, or even damage the
transmission.
Maintenance cycle and maintenance instructions
To Next Page
Loading...
