14
a) Switch off power voltage.
b) Simultaneously press and hold down and and
switch the power supply back on.
c) After a few seconds the led will light: .
d) Release keys and , the two red LEDs will now
Press followed by :
if green LED (SX) is lit: mode enabled,
if red LED (SX) is lit: press to enable.
a) Switch off power voltage.
a) Press and hold it down and simultaneously
switch the power supply back on.
b) After a few seconds the LEDs will light:
.
c)Release,thetworedLEDswillnowash.
a) Switch off power voltage.
b) Press and hold it down and simultaneously
switch the power supply back on.
c) After a few seconds the LEDs will light: .
d)Release,thetworedLEDswillnowash.
3.1.1 Card initialisation
Allthevaluespreviouslystoredonthecardareerasedandtheautomationisdened.
3.1.2 Resetting travel and functions
The travel, function modes and functions set are erased.
3.1.2 Resetting the travel
Thetravelvaluesandfunctionmodesareerased;thepreviouslysetfunctionvaluesremain.
3.2 Function modes
5 different selectable function modes are envisaged: DEAD MAN, SEMI-AUTOMATIC, 2-STEP AUTOMATIC, 4-STEP AUTOMATIC and
CONDOMINIUM. The selection of one mode excludes the others.
3.2.1 Dead man
Inthismode,gatemovementonlytakesplaceifthe‘step’keyishelddown(remotecontrol,selector)anditstopswhenthekeyisreleased.
To Next Page
Loading...
