18
Press followed by :
The force value is set by pressing and .
DYNAMIC FORCEadjustment
Thedynamicforceisadjustedduringthe4phases
of movement of the two leafs.
Theadjustmentofthedynamicforceforleaf1is
obtainedusingthePEDESTRIANcommand(leaf1
onlymoves).
Theadjustmentofthedynamicforceforleaf2is
obtainedusingtheSTEPcommand(bothleafs
movebutleaf2onlyisadjusted).
The force value is set by pressing and .
3.3.8 Force
The function regulates the thrust and therefore the speed of the automation.
The total force is obtained by adding two components:
BASE FORCE + DYNAMIC FORCE = TOTAL FORCE The BASIC FORCE is a constant component over all phases.
The DYNAMIC FORCEisanindependentlyadjustablecomponentoverthefourOPENING, DECELERATION IN OPENING, CLOSURE,
DECELERATION IN CLOSURE phases and on the two leafs.
The deceleration phases are characterised by a preset reduction in the TOTAL FORCE.
For the FORCE function automatic exit of programming is not envisaged. To quit force programming press .
Press followed by :
ifgreenLED(SX)islit:timescalefrom5to20
seconds on,
ifredLED(SX)islit:timescalefrom25to125
seconds on.
The various times are set by pressing and .
Press to change the scales.
3.3.9 Pause time
This function regulates the pause time before automatic re-closure.
20 s
40 s
80 s
120 s
160 s
VALUE
LEDS ON
200 s
Press followed by .
The various times are set by pressing and .
3.3.10 Courtesy light
The courtesy light function switches on a light during any gate movement. The light can remain on after the last manoeuvre for a settable time of
20–200s.