To Next PageTo Next Page
Need help?Do you have a question about the Life GE UNI 24R and is the answer not in the manual?
General| Brand | Life |
|---|---|
| Model | GE UNI 24R |
| Category | Gate Opener |
| Language | English |
Provides general instructions and warnings for installation, use, and maintenance of the control unit.
Details the standard installation procedure for the gate automation system.
Adjusting the stop plates for gate opening and closure.
Procedure for identifying radio controls with the system.
Identifying the closure stop plate for gate leaf 2 and leaf 1.
Identifying the staggering and opening stop plates for gate leaves.
Identifying the closure staggering for gate leaves.
Procedure for resetting the control unit to default settings.
Illustrates the electrical connections and components of the control unit.
Essential checks, GEBOX installation, and control unit connections.
Wiring diagrams for the right-hand side and lower part of the control unit.
Step-by-step guide for assembling and mounting the GEBOX enclosure.
Outlines a quick installation process for lightweight gates with a 90-degree opening.
Process for initializing the control unit card and one touch programming.
Overview of control unit startup, keyboard, and LEDs.
Steps for general initialisation and gate travel identification.
Procedures for STEP, Pedestrian command identification, and radio control resetting.
Resetting all controls and identification without using the keyboard.
Manual programming for 2-leaf and single leaf gates.
Card initialisation, resetting, and function mode selection including Dead Man.
Configuration for Semi-automatic, 2-Step, and 4-Step automatic modes.
Settings for Condominium, Blackout, Pre-flashing, and Flashing in Pause.
Settings for Photo 1, Close After Photo, and Opening Ram Blow.
Adjusting force, pause time, and courtesy light functions.
Settings for deceleration, obstacle detection, and pedestrian opening.
Information on fuses and selection of preset functions F1 & F2.
Buffer battery installation and malfunction signals with remedies.
Guidance on flashing light functions and automation malfunction indicators.
Manufacturer details and intended use of the control unit.
General and storage safety instructions and warnings.
Procedures for testing and trial run of the automation system.
Guidelines for the initial operation and checks after installation.
Maintenance instructions, warnings, and routine tasks.
Procedures for the proper demolition and disposal of the unit.
Declaration of the product's compliance with EU directives.
Information on residual risks to be communicated to the owner.
