EasyManua.ls Logo

Life GE UNI 24R - Closure Staggering Identification; Control Unit Resetting

Default Icon
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
PHASE 7
IDENTIFICATION OF CLOSURE STAGGERING.
a) Give the step command (A) and release, the leaf (2) will close.
When it reaches the point at which one also wishes to close
leaf (1) (closure staggering) give the step command (A) and
release: leaf (1) will also close. The two leafs will now continue
to close until they reach and push against the opening stop
plates for a few seconds.
b) When both leafs (1) and (2) have reached the closure stop plate,
check that the two green LED sash and that the two red
LEDS are lit.
EL0021c
EL0021c
1
2
3
4
5
6
7
8
9
10
F1
F2
UOMOPRESENTE
SEMIAUTOMATICO
AUTOMATICO 2 PASSI
BLACH-OUT
AUTOMATICO 4 PASSI
CONDOMINIALE
PRELAMPEGGIO
LAMPEGGIO IN PAUSA
FOTO 1
CHIUDE PASSANDO
FOTO TEST
COLPO D`ARIETE
LUCE DI CORTESIA
RALL APERTURA
APERT. PEDONALE
FORZA
TEMPO PAUSA
RALLENTAMENTO IN CHIUSURA
SENSIBILITA` MOTO
EL0016
EL0016
A
EL0016
EL0016
A
EL009
EL009
1
2
EL006f
EL006f
1
2
EL0012
1
2
EL0012
RESETTING THE CONTROL UNIT
EL0014
EL0014
EL0021d
EL0021d
1
2
3
4
5
6
7
8
9
10
F1
F2
UOMOPRESENTE
SEMIAUTOMATICO
AUTOMATICO 2 PASSI
BLACH-OUT
AUTOMATICO 4 PASSI
CONDOMINIALE
PRELAMPEGGIO
LAMPEGGIO IN PAUSA
FOTO 1
CHIUDE PASSANDO
FOTO TEST
COLPO D`ARIETE
LUCE DI CORTESIA
RALL APERTURA
APERT. PEDONALE
FORZA
TEMPO PAUSA
RALLENTAMENTO IN CHIUSURA
SENSIBILITA` MOTO
a) Switch of the system’s power supply.
b) Press and switch on the system’s power supply until all
four LEDs light.
UOMO PRESENTE
SEN. AUTOMATICO
AUTOMATICO 2 PASSI
AUTOMATICO 4 PASSI
1
2
A
B
UOMO PRESENTE
SEN. AUTOMATICO
AUTOMATICO 2 PASSI
AUTOMATICO 4 PASSI
1
2
A
B
a) While the operator (1) moves when opening or closing the green
LEDs and left red LED ash alternately.
b) While the operator (2) moves when opening or closing the green
LEDs and right red LED ash alternately.
6
The automation is now programmed. The automation is now in semi-automatic mode by default.
If you are dissatised with the result obtained, reset the control unit and repeat procedure from start.
EL0015
EL0015
ON
230V
ON
OFF
230V
OFF
2 MAN.ISTRUZ.GE UNI24R (GB).indd 6 30-10-2008 16:40:56

Table of Contents

Related product manuals