Lighthouse S3100/S5100/Boulder Counter Operating Manual
6-58 248083389-1 Rev
• Time - Indicates the instrument time at which the data was
recorded (HH:MM:SS).
• Instr - Indicates the state of the instrument at the time the data was
recorded. Instrument states include GOOD or SRVC.
If SRVC appears, printouts will say “Service Required” and the
sensor may need cleaning. Please contact Lighthouse Technical
Support at 800-945-5905 (USA Toll Free) or 541-770-5905
(Outside of USA).
• Flow - Indicates the flow state of the instrument at the time the data
record was recorded. Flow is recorded as OK or ALRM. If the flow
was in alarm, it will print as Flow: Alert on the printouts.
• Alarm - Indicates (NONE or YES) if the data record exceeded any
of the alarm thresholds of any of the channels that were enabled for
alarms. If the data record exceeded alarm thresholds, printouts
show "Alarm: Yes".
• Laser - Indicates the status of the laser at the time the data record
was recorded; possible laser states include OK or SRVC. If the laser
needs to be serviced, it will print as Laser: Service.
If laser state is SRVC, please contact Lighthouse Technical Support
at 1800-945-5905 (USA Toll Free) or 541-770-5905 (Outside of
USA).
Printing Data
View Buffer
Reports
The SOLAIR 1.0 CFM instruments store up to 3000 records in the data
buffer.
The Buffer Report prints all or a range of the records in the buffer in the
format specified by selections in the Print Configuration menu. At the
end of the Buffer Report, a Summary will display or print the following
information:
• Data displayed in Cumulative or Differential mode
• Raw ("Particle Counts") or Normalized ("Particles/ft
3
" or
"Particles/m
3
")
• # of samples in the report
At each channel size:
• Maximum Value
• Minimum Value
• Average
• Standard Deviation
To Next Page
Loading...
