Unpacking, Inspecting and Installing
248083389-1 Rev 3-13
Connecting an External Peripheral Device
An external peripheral device, such as a light stick, a buzzer or a
remote control device can be connected to the back of the SOLAIR via
the Peripheral Interface Connector.
Information regarding the pinouts of this connector can be found in
Chapter 4 under Peripheral Interface Connector, page 4-5.
Connecting to an External Computer or Facility
Management System
WARNING: NOTE:
+24VDC is present on
Pin 7 of the RS-485
connector when power is
applied to instrument.
SOLAIR family instruments can be connected to the Lighthouse
Monitoring System, LMS Express/RT or the LMS XChange Data
Transfer Software in order to download data.
Note:
LMS Express
allows download of data
from the instrument; LMS
Express RT provides real
time data downloads.
The SOLAIR 1.0 CFM instruments have three ports available for
flexible external data retrieval. It can connect to the Lighthouse
Monitoring System, LMS Express/RT or the LMS XChange Data
Transfer Software for data download.
By transferring the SOLAIR data to the Lighthouse Monitoring System
(LMS) or LMS Express, the user can store historical data on a server or
PC for future review and trending. In LMS XChange, data can be
exported to a *.csv file for historical review. Up to 200 alphanumeric
location names can be transferred between LMS XChange and the
SOLAIR.
For specifics on connecting to the instrument, see “Overview” on
page 5-1. Refer to the LMS, LMS Express or LMS XChange manual
for specific information about their set up and use.
To Next Page
Loading...
