Page 141 of 192
Recommendations
• When the system is overloaded, LINAK recommends to use quick release actuators in the application. These will allow functions to be lowered
manually in case of a PJ2 malfunction due to misuse/abuse.
• If the customer has other basic safeties than “no unintended movement”, he must consider this in his own risk analysis.
LINAK disclaims any liability.
• If the actuator or the control cable is removed from the control box, the cable lock must be applied. To ensure movement in this case,
LINAK recommends to use quick release actuators in the application.
• If the cable is damaged by pulling, LINAK recommends to make a safe cabling. If movement is an essential performance, LINAK recommends
to apply quick release actuators, for example, to ensure movement.
• If the thermal protection is activated due to current overload when operating multiple actuators and/or excessive duty cycle, the operation must
be kept within the specification. If movement is an essential performance, LINAK recommends to apply quick release actuators, for example,
to ensure movement.
• Sales must request a review of the products according to current cut-off limits.
Warnings:
• Use EPR or ensure that the user takes care not to squeeze the mains cable.
• Always check correct assembly after mounting and service to ensure that the cable lock is mounted.
(Connectors are usually removed during cleaning)
• Always use approved chemicals with the housing as the plastic may show corrosion caused by some chemicals. As a result water
may accumulate/gather in housing.
• Take special precautions concerning 3
rd
party interfacing. Please contact LINAK for further information.
• Make a review of all product specifications before system set-up if the current cut-off limit is higher than the maximum allowed
current cut-off for the actuator.
• To avoid cable interruption and actuator defects make a proper cable installation and inspect regularly for wear and damage.
Defective parts must be replaced.
• After service inspection, the application must be tested for correct functionality before it is put into operation to avoid actuator plugs
being mixed during service.
Operators must not be inside entrapment area.
• To avoid electrical failure or system disturbance inspect regularly for wear and damage. Defective parts must be replaced.
• Make a proper cable installation to avoid short-circuit cables for handset/controls.
Regular inspection must be made for wear and damage. Defective parts must be replaced.
• Do not mount the actuator with the spindle facing downwards to avoid that the actuator slips off the bracket with the mounted PJ2.
The bracket can come loose when exposed to shock or hard vibration, for instance when passing doorsteps.
Regular inspection must be made to ensure proper fixation of control box and bracket on actuator.
• PJ2 is ONLY to be used with PCP 2.0 control boxes.
To Next Page
Loading...
Need help?
General
