Page 18 of 192
Insulation class
LINAK
®
control boxes are available in insulation class 1 and insulation class 2.
Key to symbols
The following symbols are used on the LINAK product labels:
Recycle
Recognised
Component mark for Canada and the United States
PSE mark
Compliance to all relevant EC directives
China
Pollution control mark (also indicates recyclability)
Regulatory compliance mark:
The Australian Safety/EMC Regulations
Alternating current
Direct current
Reduced ETL recognised component mark for
Canada and the United States.
X: The mark is always accompanied by a control
number of 6 or 7 figures.
For complete description, see ETL marking on
next page.
IEC 60417-5172:
Class II equipment
Product with a thermofuse
IEC 60417-5957:
For indoor use only
IEC 60417-5222:
Safety isolating transformer, general
IEC 60417-5840:
Patient part of type B
IEC 60417-5019:
Protective earth; protective ground
IEC 60417-5002:
Positioning of cell
ISO 7000-0434A:
Caution, consult accompanying document
ISO 7000-1641
Operating instructions
Electronics scrap
Electronics scrap
XXXXXX
To Next Page
Loading...
Need help?
General
