Page 99 of 192
The LP2 lifting column is the ideal choice for duties such as height adjustment on computer workstations, work benches, or a wide selection of other duties.
• There are mounting holes in the end plates.
• The largest profile must be mounted uppermost.
The LP2 range of vertical lifting columns is ideal where vertical positioning of
substantial loads is required.
The design allows the LP2 range to be built in a complete motion control system
simply by adding a suitable LINAK control box and hand control.
Advanced design and high quality construction allows the column to be operated
either as single or parallel with up to a maximum of four units and/or with a memory
function.
Warning
Do only use the column within specified working limits.
Warning
Ensure a safe connection between column and application
Warning
Side mounting bracket screws: use the correct torque on the side mounting bracket screws.
Warning
The column can not be used in pull
Warning
Max. bending: LP22 = 550 Nm
LP25 = 1000 Nm
5. LP2 (DESKLINE
®
MEDLINE
®
CARELINE
®
TECHLINE
®
)
To Next Page
Loading...
Need help?
General
