Need help?Do you have a question about the Lindab FDS-M and is the answer not in the manual?
The main unit for communication with up to 60 fire dampers and smoke detectors.
Slave unit for connecting additional dampers and detectors, needed for more than four dampers.
Instructions for providing 230V AC power supply to the FDS-M master unit.
Guide for connecting up to four fire dampers directly to the FDS-M master unit.
Instructions for connecting up to four smoke detectors directly to the FDS-M master unit.
Steps to connect the first FDS-S slave unit to the FDS-M master and FDS-P power supply.
How to connect a single fire damper to an FDS-S slave unit.
Instructions for connecting a single smoke detector to an FDS-S slave unit.
Guide for connecting multiple FDS-S slave units sequentially using RS485 communication.
Instructions on how to connect the FDS-R signal repeater to slave units.
How the FDS-M master unit receives and acknowledges external alarm inputs.
How the FDS-M master unit sends fire and service alarms via relay module FDS-RB.
Details on connecting the "Stop AHU" signal to the FDS-M master unit using a relay module.
Provides examples of required components based on system configuration.
Steps to select the correct country setting for the FDS Master unit.
Explains user and service access rights and how to log in to the system.
Outlines the hierarchical menu structure accessible after logging into the FDS Master.
Guide to navigating and viewing the status of fire dampers, detectors, and I/O signals.
How to view and adjust damper duration times and reset detectors.
Detailed steps for selecting the country setting within the commissioning menu.
Explains how to automatically assign addresses and IP addresses to slave units.
Instructions for manually assigning addresses and IP addresses to slave units.
Procedure for connecting a single smoke detector to the FDS-M unit without a fire damper.
How to group fire dampers and smoke detectors into logical sections for management.
Configuration options for TCP-IP communication, including IP address, subnet mask, and gateway.
Steps to activate or deactivate the entire fire damper system.
Procedures for performing fabrication or application resets on the system.
Accessing and configuring various miscellaneous settings, including I/O status and damper parameters.
Configuration for system language.
Setting up and performing test exercises for individual dampers or all dampers.
Performing alarm tests, damper tests, and manual operations on the system.
Adjusting system date and time, and saving current damper durations.
How to navigate and review the list of recorded alarm events in the system.
General| Category | Fire and Smoke Dampers |
|---|---|
| Brand | Lindab |
| Model | FDS-M |
| Material | Galvanized steel |
| Max air velocity | 12 m/s |
| Control options | 24V AC/DC, 230V AC |
| Fire resistance rating | EI 60 |
| Leakage class | Class 3 |
| Standards compliance | EN 15650, EN 13501-3 |
| Actuation | Electric actuator |
To Next Page
