6.5 Commissioning
Access right
Status
Commissioning
Settings
Activate/Deactivate
Resets
Miscellaneous
Country
Addressing
Sections
Communication
6.5.1 Country
OK
Press and move to choose the country.
Press to go back.
Country
Country
Other countries
6.5.2 Automatic addressing
Automatic addressing means that number of damper
and its IP address are automatically assigned to the
system in sequence by pressing the right button in the
FDS-S as described below.
ATTENTION!
Dampers connected to the slave units FDS-S can be
addressed in AUTOMATIC mode as well as in MANUAL
mode.
Dampers connected directly to the master unit
FDS-M can be only addressed in MANUAL mode.
Go to the ADDRESSING display on master unit.
Addressing
Automatic
Manual
Add single detector
Automatic addresmode
Address Mode: NO
To Next Page
Loading...
