Servicing 5
Inspection and maintenance as required
¾ Tighten the wheel fastenings crosswise
with a torque of 210 Nm.
e3861317
Tighten wheel fastenings
The wheel fastenings should be tightened
before initial commissioning and whenever
wheels are changed or repairs are made.
After this tightening should be performed after
100 operating hours at the latest.
The wheel fastenings should b
e tightened
crosswise with a torque of:
front
210 Nm
rear
210 Nm
.
Other cleaning and greasing
When used indoors in clean dry conditions, it
is generally sufficient to perform maintenance
every 1000 operating hours. If used both in-
doors and outdoors, cleaning / greasing is
recommended between 500 and 1000 operat-
ing hours, however not later than 12 months.
Operating Instructions – 386 807 1001 EN – 03/2006 103
To Next Page
Loading...
