Operation 4
Standard equipment
Standard equipment
Adjust driver’s seat
WARNING
An incorrect sitting position may damage the dri-
ver’s back in terms of health. The adjustment de-
vices for the driver’s seat should not be used during
operation.
Whenever starting up the vehicle and changing
drivers adjust to the individual weight of the driver
and check that all setting positions have snapped
into place properly. Do not store any objects in the
driver’s range of motion .
Longitudinal adjustment
WARNING
There is a risk of crushing if the lever is grasped
fully.
Only grasp the lever by the trough provided for this
purpose.
e3861381
1
¾ Lift lever (1).
¾ Move the driver’s seat on the slide rails
backwards or forwards to give the driver
the best position in relation to the steering
wheel and the accelerator pedals.
¾ Allow lever (1) to snap back into place.
Adjust to driver’s weight
NOTE
Adjustment to the individual driver’s weight
must be made with the driver’s seat under load
.
Operating Instructions – 386 807 1001 EN – 03/2006 25
To Next Page
Loading...
