Servicing 5
Inspection and maintenance every 3000 operating hours or every 2 years
Check the condition and secure po-
sitioning of electric cables, cable
connectors and connections
NOTE
Oxidised connections and brit
tle cables result
in voltage drops , so causing
malfunctions.
e3861394
¾ Remove the screws from the floor plate
fastening (pedals) and lift up floor plate.
¾ Check all electric cables and connections
on contactor support.
¾ Cable connections on electri
c motors:
check plug connections for s
ecure posi-
tioning and oxidation resid
ues.
¾ Check battery cables for secure positioning.
¾ Check electric wiring for abrasion and se-
cure positioning.
¾ Check earth wire for secure pos
itioning.
¾ Remove oxidised connections and replace
brittle cables.
Operating Instructions – 386 807 1001 EN – 03/2006 125
To Next Page
Loading...
