Servicing 5
Checks prior to starting work
Check tyres
¾ Operate parking brake
The truck must be secured so that it cannot roll
away.
¾ Place chock under wheel not to be l
ifted.
¾ Raise truck with jack until wheels are off the
ground.
e3861316
¾ Place pieces of timber underneath.
¾ Check for free movement of wheels and
remove anything hindering their movement.
¾ Replace worn or damaged tyres.
Pneumatic tyres
NOTE
Pneumatic tyres are spe
cial equipment.
CAUTION
If the pressure is too low, this will reduce the life of
the tyre and impair the stability of the truck.
The specified tyre pressure should always be
checked regularly.
¾ Check tyres for specified tyre pressure.
¾ If necessary, adjust tyre pressure according
to data.
Truck with turntable axle
front: 18x7-8
(16PR)
10 bar
E12
E14
E15
E16
rear: 15x4 1/2-8
(12PR)
10 bar
Truck with combi-steering axle
front: 18x7-8
(16PR)
10 bar
E16P
rear: 16x6-8
(10PR)
8bar
Tyres made of solid material
The trucks are generally equipped with tyres
made of solid material, so-called superelastic
tyres (SE).
NOTE
The individual tyre types and sizes can also be
found in the data sheets (section 6 Technical
data).
Truck with turntable axle
front: 18x7-8 SE
E12
E14
E15
E 16 Flat design
rear: 15x4 1/2-8 SE
front: 18x7-8 SE
E16
High design
rear: 16x6-8 SE
front: 200/50-10 SE
E18
rear: 140/55-9 SE
Truck with combi-steering axle
front: 18x7-8 SE
E16P
rear: 16x6-8 SE
front: 200/50-10 SE
E18P
E20P
rear: 16x6-8 SE
Operating Instructions – 386 807 1001 EN – 03/2006 89
To Next Page
Loading...
