LINET Virtuoso 3 Series User Manual

41/65D9U003VB3-0101_04
Tottheaccumulatorback-uppack:
 Disconnect SCU from mains.
 Mute audio alert signal (see „Mute“ - chapter 11.2.2).
 Make sure the bottom side of the accumulator with label is oriented correctly.
 Push accumulator pack into mounting slots 1 until it clicks into place.
 Switch SCU back on.
Toremovetheaccumulatorback-uppack:
 󰀨
 Pull down the accumulator pack’s release tab 2.
 Pull out accumulator pack while holding down release tab.
NOTE There is no need to remove the accumulator pack except when replacing it.
10.2.1 Detectionofthecorrectlyinsertedaccumulator(withMainspowerswitchturnedon)
Accumulator is correctly inserted to SCU when the Accumulator Charge Status Indicator is lit for 2 seconds and the
acoustic signal sounds for 2 seconds after the Accumulator power switch is turned on. The Accumulator Charge Indicator
󰀨-
mulator by Accumulator power switch, it is necessary to wait at least 10 seconds for correct function of the accumulator
detection before the Accumulator power switch is turned on again.
2
1
Fig. Accumulator Release Button on the bottom of SCU
Fig. Fitting the accumulator pack
Fig. Removing the accumulator pack

LINET Virtuoso 3 Series Specifications

General

Brand	LINET
Model	Virtuoso 3 Series
Category	Indoor Furnishing
Language	English