Linksys LRT224

16
Setup
Linksys
NOTE:
Remember to click Save before leaving the page. You can also click Cancel
to undo the changes.
Port Forwarding and Port Triggering
You can set up a port forwarding virtual host to allow public access to servers
connected to the LAN ports. Port Forwarding opens a specified port or a port
range for a service, such as FTP, WWW, and mail, etc. Port Triggering opens a
port range for services that use alternate ports to communicate between the
server and LAN host. Use the Configuration > Setup > Forwarding page to
configure.
• PortRangeForwarding
• PortTriggering
NOTE Remember to click Save before leaving the page. You can also click
Cancel to undo the changes.
Port Range Forwarding
Port forwarding can be used to set up public services on your network. When
users from the Internet make certain requests to your network, the router
can forward those requests to computers that are equipped to handle the
requests. If, for example, you set the port number 80 (HTTP) to be forwarded
to IP address 192.168.1.2, then all HTTP requests from outside users will be
forwarded to 192.168.1.2.
To set up other services input the server TCP or UDP port number and the
virtual host IP addresses.
Service Select the service. You can also add a new service from
Service Management.
IPAddress Input the LAN IP address of the virtual host.
Interface Select the WAN port. (Dual WAN router only)
Addtolist Click the button to add a new entry.
Update Select the entry that you want to modify. Change the setting
and then click Update. Clicking Add New deselects the entry
and clears the text fields.
Delete Click the entry and then click Delete.
View To view the entry table, choose Port Range Forwarding or
Port Triggering.Click Refresh to renew the display. Click Close
to return to configuring page.