Linksys LRT224

19
Setup
Linksys
Service Select the service. You can also add a new service
from Service Management.
NameorIPAddress Input the Intranet virtual IP address or host name.
Enable Activate this function.
ServiceManagement Add or remove service ports from the
management list.
AddtoList Click the button to add a new entry.
Update Select the entry that you want to modify. Change
the setting and click Update. Clicking Add New
deselects the entry and clears the text fields.
Delete Click the entry and then click Delete.
View To view the entry table, click Refresh to update the
display. Click Close to return to configuring page.
Adding a service
To add a new service item or to edit an existing service, click Service
Management. If the web browser displays a warning about the pop-up
window, click to allow the blocked content.
In the Service Management window, add or edit entries as needed. After
setting a rule, be sure to click OK to save your settings or click Cancel to undo
them.Toaddaservicetothelist:Enter
• ServiceName:Give a name to the service.
• Protocol:Choose the required protocol: TCP, UDP or IPv6.
• PortRange:Enter the port range.
• Toaddanothernewservice:enter the information, and click Add to list.
• Toeditaserviceyoucreated: , select the service in the list and click
Update to make the changes. If you do not need to make changes, click
Add New to deselect the service and clear the text fields.
• Todeleteaservicefromthelist,clickDelete.
One-to-One NAT
If your ISP issued more than one actual IP (such as eight ADSL static IP
addresses or more), you can map the remaining real IP addresses to the
intranet devices with virtual IP addresses.
You can also map a private IP address range to a public IP address range of
equal length (for example, five private addresses and five public addresses).
The first virtual address will be mapped to the first external address.
Use the Configuration > Setup > One-to-One NAT page to enable One-to-One
NAT (Network Address Translation).
NOTERemember to click Save to save your settings before leaving the page.
You can also click Cancelto leave without any change.