Linksys LRT224

60
EasyLink VPN
Linksys
60
EasyLink VPN
Summary
EasyLink VPN replaces the conventional complicated VPN setup process by
entering Server IP, User Name, and Password.
Go to Configuration > EasyLink VPN > Summary to see the summary page.
EasyLink VPN Server Status
Enable Indicates whether EasyLink VPN server is
enabled or disabled. You can go to EasyLink
VPN Server setting page to change the
configuration.
Protocol Indicates current EasyLink VPN handshaking
protocol.
Encryption/ Authentication/
DH Group
Indicates encryption /authentication/ DH
Group mode. For example, 3DES/ MD5/ Group
2 -1024 bit
Config. Click the Edit icon to get into EasyLink VPN
Server setting page.
Inbound EasyLink VPN Status
Use the Rows per page list at the top right corner of the table to decide the
number of rules to display on each page and use the Page list to choose a
particular page.
Enable Indicates whether the specified EasyLink VPN client is
enabled or disabled. You can go to Inbound EasyLink VPN
setting page to change the configuration.
Account Indicates the user names of remote clients.
Status The status of the tunnel: Connected or Waiting for
Connection.
Local Group The setting for VPN connection secure group of the local
end.
Remote Gateway The IP address of the Remote Gateway.
Remote Group Setting for remote VPN connection secure group.
Tunnel Test Click Connect to verify the tunnel status. The test result
will be updated.
To disconnect, click Disconnect to stop the VPN connection.
To delete tunnel settings, select a tunnel, and then click
the Delete icon.
Config Click the Edit icon to get into Inbound EasyLink VPN
setting page. You can also click the trash can icon to delete
the client configuration.
You can also click on Add, below the EasyLink VPN client table, to configure a
new Inbound EasyLink VPN client (initiator).
Outbound EasyLink VPN Status
Use the Rows per page list at the top right corner of the table to decide the
number of rules to display on each page and use the Page list to choose a
particular page.
Enable Indicates whether the specified Outbound EasyLink VPN
is enabled or disabled. You can go to Outbound EasyLink
VPN setting page to change the configuration.
Account The user names for linking to the remote EasyLink VPN
server.
Status The status of the tunnel: Connected or Waiting for
Connection.
Local Group The setting for VPN connection secure group of the local
end.
Remote Gateway The IP address of the Remote Gateway.
Remote Group The setting for remote VPN connection secure group.