Linksys LRT224

68
Log
Linksys
Syn Flooding Heavy syn packet transmission in a short time overloads the
system.
IP Spoofing Hackers use packet sniffing to intercept data transmitted on
the network. They then change the sender’s IP address to
access the source system.
WinNuke Servers are attacked or trapped by a trojan program.
Ping of Death The system fails because the sent data exceeds the maximum
packet that can be handled by the IP protocol.
Unauthorized
Login Attempt
If intruders into the device are identified, the message will
be sent to the system log.
General Log Click to activate the features, including System error message,
blocked regulations, regulation of passage permission, system configuration
change and registration verification.
System Error
Messages
Identifies system errors.
Deny Policies Records when remote users fail to enter the system because
of access rules.
Allow Policies Records when remote users enter the system through
successful authentication.
Configuration
Changes
Records changes in the system’s configuration.
Authorized
Login
Records authorized logins.
Four buttons for interaction with the system log online.
View System
Log
Read message content online via the device.
Outgoing Log
Table
View log packets that have been sent out from the PC to
the Internet. Information includes LAN IP, destination IP, and
service port.
Incoming Log
Table
View system packet log of those entering the firewall.
Information includes external source IP addresses,
destination IP addresses, and service ports.
Clear Log Clears all the current information on the log.
System Statistics
Go to Configuration > Log > System Statistics page to view statistics of all router
interfaces.
Click Refresh button to update the statistics.
Interface Indicates interface: WAN, LAN and DMZ.
Device Name Port ID: eth0, eth1, eth2, and so on.
Status Port status: Connected, Disconnected, Enabled, or
Disabled.
IP Address IP address.
MAC Address MAC address.
Subnet Mask Subnet mask.
Default Gateway Default gateway IP address.
DNS DNS server.
Received Packets Number of received packets.
Sent Packets Number of sent packets.
Total Packets Number of packets sent and received.
Received Bytes Number of received bytes.
Sent Bytes Number of sent bytes.