Linksys LRT224

61
EasyLink VPN
Linksys
Tunnel Test Click Connect to verify the tunnel status. The test result
will be updated. To disconnect, click Disconnect to stop
the VPN connection.
To delete tunnel settings, select a tunnel, and then click
the Delete icon.
Config To disconnect, click Disconnect to stop the VPN
connection.
Inbound EasyLink VPN
This page allows the administrator to add a new inbound EasyLink VPN user
(intiator). The role of the router is responder.
Go to EasyLink VPN > Inbound EasyLink VPN to add a new remote user
configuration.
NOTE:
Click Save before leaving the page or the configuration will be abandoned.
Click Cancel to undo the changes.
NOTE:
To edit an existing inbound Easylink VPN user, go to Easylink VPN summary
page and click the Edit icon of the corresponding VPN user.
Add a New Account
VPN Role Indicates the role of the router is Responder.
Enable Indicates whether the specified inbound EasyLink
VPN account is enabled or disabled.
Account Name The username of remote user.
Password The user password of remote user.
Authentication Port Indicates authentication port.
Local Security Group
Type
Local security group type is Subnet.
IP Address Input LAN IP address of the router.
Subnet Mask Input subnet mask of the router.
Outbound EasyLink VPN
This page will introduce how to configure outbound EasyLink VPN. The role of
the router is a tunnel initiator.
The router only supports one outbound Easylink VPN connection.
Go to EasyLink VPN > Outbound EasyLink VPN to configure.
NOTE:
Click Save before leaving the page or the configuration will be abandoned.
Click Cancel to undo the changes.
Edit Account
VPN Role Indicates the role of the router is Initiator.
Enable Check to enable outbound Easylink VPN connection
or uncheck to disable.
Account Name Input the username to make an outbound Easylink
VPN connection.
Password Input the required password to make an outbound
Easylink VPN connection.
Primary Server Input the IP address of remote server.
Secondary Server Input the IP address of secondary remote server.
Authentication Port Select the authentication port.
Keep Alive Check the box to enable Keep Alive.
Local Security Group
Type
Indicates local security type as Subnet.
IP Address Input local IP address.
Subnet Mask Input local subnet mask.