Linksys LRT224

20
Setup
Linksys
EnabledOnetoOneNAT: Check to enable the One-to-One NAT function.
PrivateRangeBegin: Input the Private IP address for the Intranet
One-to-One NAT function.
PublicRangeBegin: Input the Public IP address for the Internet
One-to-One NAT function.
RangeLength: Input the numbers of final IP addresses of
actual Internet IP addresses. (Please do not
include IP addresses in use by WAN ports.)
AddtoList: Add this configuration to the One-to-One NAT
list.
Update: Select the entry that you want to modify.
Change the setting and click Update. Clicking
Add New will deselect the entry and clear the
text fields.
Delete: Click the entry and then click Delete.
Setting MAC Clone
Some ISPs ask for a fixed MAC address (network card physical address) for
distributing IP addresses. Users can input the network card physical address
(MAC address: 00-xx-xx-xx-xx-xx) here. The Linksys LRT series router will adopt
this MAC address registered to your ISP. Use the Configuration > Setup > MAC
Address Clone page
Click Edit to get into configuring page.
MAC Clone Settings
NOTE:
Remember to click Save before leaving the page. You can also click Cancel
to leave without any change.
To clone a MAC address, enter the following settings. Select the interface you
want to configure if the router supports dual WAN ports.
UserDefinedWANMACAddress: Check this item to manually clone a
MAC address. Enter the 12 digits of the
MAC address that you registered with
your ISP.
MACAddressfromthisPC: Check this item to clone the MAC
address of the device you are currently
using.
The MAC address of your PC is
displayed automatically.