Linksys SPA941 - Star Code to Activate;Deactivate Certain Services

DRAFT
© 2003 - 2005 Linksys, a Division of Cisco Systems Proprietary (See Copyright Notice on Page 2)
33
• Waveform – 1, 2, 3, or 4
• Cadence – 1, 2, 3, …, or 8
The user can assign a default ring tone for each extension. The user can assign a ring tone for each
personal directory entry (which overrides the default ring tone). Ring tone can be selected from the GUI.
In addition, the SPA941 allows 2 user-downloadable ring tones. Therefore a total of 12 ring tone choices
are available to the user to be used as default ring for an extension or assigned to individual callers in the
personal directory. The user downloaded ring tone as labeled as "User 1" and "User 2" in the choices for
the <Default Ring>. On the phone ring tone menu, the User 1 and 2 choices are replaced by the
corresponding name of the ring tone or “Not Installed” if the user ring tone slots have not been
downloaded into.
The user ring tone (1 or 2) can be downloaded using the phone web interface with the link:
http://<phone-ip-addr>/ringtone1[?<url>]
where <url> syntax is [tftp://][host[:port]]/<path>. Only tftp is supported. If host is not specified, the TFTP
host is the web client; default port is 69.To remove user ringtone 1 from the phone, set the <path> to
"delete", such as:
http://<phone-ip-addr>/ringtone1?/delete
The link is case sensitive.
Notes:
• For User Ring Tone 1 and 2, the cadence is fixed with the on-time equals to the duration of the ring
tone file and off-time equals to 4s. The total ring duration is fixed at 60s.
• The user ring tone names displayed on the phone GUI are extracted from the ring tone file header file
• No need to reboot phone after a ring tone download.
• However, if your phone is already in ring tone GUI menu while the new ring tone is downloaded, you
will need to exit and re-enter the ring tone menu in order to see the new ring tone name on the menu.
Star Code to Activate/Deactivate Certain Services
THE SPA941 accepts star codes to activate or deactivate certain services on the phone. Below is a list of
services that are accessible with a star code, with the default star code shown in parenthesis:
• Call Return (*69) – call the last caller, regardless which extension
• Call Back(*66) – Periodically redial the last busy number (every 30s by default) until it rings or
until the trial expires (30 min by default), regardless which extension. Only 1 call back operation
can be ordered at a time. A new order will automatically cancel the last order.
• Cancel Call Back(*86) – Cancel the last call back operation
• Call Forward All (*72) – Call forward all inbound calls. Applicable to primary extension only