DRAFT
© 2003 - 2005 Linksys, a Division of Cisco Systems Proprietary (See Copyright Notice on Page 2)
52
“Manual,DHCP”, “DHCP,Manual”: Both DNS servers
supplied by DHCP server and the ones statically
configured, but in different order.
DNS Query Mode Do parallel or sequential DNS Query Choice Parallel
Syslog Server Specify the Syslog server name and port. This feature
specifies the server for logging SPA system information
and critical events.
FQDN
Debug Server The debug server name and port. This feature
specifies the server for logging SPA debug information.
The level of detailed output depends on the debug level
parameter setting.
FQDN
Debug Level The higher the debug level, the more debug
information will be generated. Zero (0) means no
debug information will be generated.
Choice 0
Primary NTP
Server
IP address or name of primary NTP server. Str127
or IP
Secondary NTP
Server
IP address or name of secondary NTP server Str127
or IP
Notes:
1. Parallel DNS query mode: SPA will send the same request to all the DNS servers at the same
time when doing a DNS look up, the first incoming reply will be accepted by SPA.
2. To log SIP messages, Debug Level must be set to at least 2.
3. If both Debug Server and Syslog Server are specified, _Syslog messages are also logged to the
Debug Server.
Provisioning Parameters
Provisioning operations are gated by the Provision_Enable parameter.
Parameter Name Description Type Default
Provision Enable Master enable for configuration profile resync
operations
Bool yes
Resync On Reset Resyncs configuration profile from configuration
server whenever the SPA resets.
Bool yes
Resync Random Delay Spread interval for resync requests Time0 2
Resync Periodic Resyncs configuration profile periodically after
reset.
Time0 3600
Resync Error Retry Delay Retry interval following resync failure Time0 3600
Forced Resync Delay Maximum time SPA will wait before initiating a
resync operation if it is not idle.
Time0 14400
Resync From SIP Enables resync of configuration profile from a
SIP command
Bool Yes
Resync After Upgrade Attempt Whether or not to resync following an upgrade Bool Yes