Linksys SPA941 - Regional Parameters

DRAFT
© 2003 - 2005 Linksys, a Division of Cisco Systems Proprietary (See Copyright Notice on Page 2)
59
Regional Parameters
Call Progress Tones
Parameter Name Description Type Default
Dial Tone
1
Played when prompting the user to enter a
phone number
ToneScript 350@-19,440@-
19;10(*/0/1+2)
Second Dial Tone An alternative to <Dial Tone> when user tries
to dial a Three way call
ToneScript 420@-19,520@-
19;10(*/0/1+2)
Outside Dial Tone
1
An alternative to <Dial Tone> usually used to
prompt the user to enter an external phone
number (versus an internal extension). This is
triggered by a “,” character encountered in the
dial plan.
ToneScript 420@-16;10(*/0/1)
Prompt Tone
1
Played when prompting the user to enter a call
forward phone number
ToneScript 520@-19,620@-
19;10(*/0/1+2)
Busy Tone Played when a 486 RSC is received for an
outbound call
ToneScript 480@-19,620@-
19;10(.5/.5/1+2)
Reorder Tone
1,2
Played when an outbound call has failed or
after the far end hangs up during an
established call
ToneScript 480@-19,620@-
19;10(.25/.25/1+2)
Off Hook Warning
Tone
2
Played when the subscriber does not place the
handset on the cradle properly
ToneScript 480@-
10,620@0;10(.125/.1
25/1+2)
Ring Back Tone Played for an outbound call when the far end is
ringing
ToneScript 440@-19,480@-
19;*(2/4/1+2)
Confirm Tone This should be a brief tone to notify the user
that the last input value has been accepted.
ToneScript 600@-
16;1(.25/.25/1)"
SIT1 Tone An alternative to <Reorder Tone> played when
an error occurs while making an outbound call.
The RSC to trigger this tone is configurable
(see Section ???)
ToneScript 985@-16,1428@-
16,1777@-
16;20(.380/0/1,.380/0/
2,.380/0/3,0/4/0)
SIT2 Tone See <SIT1 Tone> ToneScript 914@-16,1371@-
16,1777@-
16;20(.274/0/1,.274/0/
2,.380/0/3,0/4/0)
SIT3 Tone See <SIT1 Tone> ToneScript 914@-16,1371@-
16,1777@-
16;20(.380/0/1,.380/0/
2,.380/0/3,0/4/0)
SIT4 Tone See <SIT 1 Tone> ToneScript 985@-16,1371@-
16,1777@-
16;20(.380/0/1,.274/0/
2,.380/0/3,0/4/0)
MWI Dial Tone
1
This tone is played instead of <Dial Tone>
when there are unheard messages in the
subscriber’s mail box
ToneScript 350@-19,440@-
19;2(.1/.1/1+2);10(*/0/
1+2)
Cfwd Dial Tone Special dial tone played when call forward all is ToneScript 350@-19,440@-