DRAFT
© 2003 - 2005 Linksys, a Division of Cisco Systems Proprietary (See Copyright Notice on Page 2)
60
activated 19;2(.2/.2/1+2);10(*/0/
1+2)
Holding Tone Indicate to the local user that the far end has
placed the call on hold
ToneScript 600@-
16;*(.1/.1/1,.1/.1/1,.1/
9.5/1)
Conference Tone Plays to all parties when a Three way
conference is in progress
ToneScript 350@-
16;30(.1/.1/1,.1/9.7/1)
Secure Call Indication
Tone
This tone is played when a call is successfully
switched to secure mode. It should be played
only for a short while (< 30s) and at a reduced
level (< -19 dBm) so that it will not interfere with
the conversation.
ToneScript 397@-19,507@-
19;15(0/2/0,.2/.1/1,.1/
2.1/2)
Notes:
1. Reorder Tone is played automatically when <Dial Tone> or any of its alternatives times out
Distinctive Ring Patterns
8 cadence scripts can be specified to be used as building blocking to construct a ring tone in a RingScript.
Parameter Name Description Type Default
Cadence 1 Cadence 1 script CadScript 60(2/4)"
Cadence 2 Cadence 2 script CadScript 60(.3/.2, 1/.2,.3/4)"
Cadence 3 Cadence 3 script CadScript 60(.8/.4,.8/4)
Cadence 4 Cadence 4 script CadScript 60(.4/.2,.3/.2,.8/4)
Cadence 5 Cadence 5 script CadScript 60(.4/.2,.3/.2,.8/4)
Cadence 6 Cadence 6 script CadScript 60(.4/.2,.3/.2,.8/4)
Cadence 7 Cadence 7 script CadScript 60(.4/.2,.3/.2,.8/4)
Cadence 8 Cadence 8 script CadScript 60(.4/.2,.3/.2,.8/4)
Control Timer Values (sec)
Parameter Name Description Type Default
Reorder Delay Delay after far end hangs up before reorder tone is
played. 0 = plays immediately, inf = never plays.
Range: 0 – 255 sec
Time0 5
Call Back Expires Expiration time in sec of a call back activation.
Ragne: 0 – 65535 sec
Time0 1800
Call Back Retry Intvl Call back retry interval in sec. Range: 0 – 255 sec Time0 30
Call Back Delay Delay after receiving the first SIP 18x response
before declaring the remote end is ringing. If a busy
response is received during this time, the SPA still
considers the call as failed and keeps on retrying.
Time3 0.5
VMWI Refresh Intvl Interval between VMWI refresh to the CPE Time3 0.5
Interdigit Long Timer
2
Long timeout between entering digits when dialing.
Range: 0 – 64 sec
Time0 10
To Next Page
Loading...
