DRAFT
© 2003 - 2005 Linksys, a Division of Cisco Systems Proprietary (See Copyright Notice on Page 2)
61
Interdigit Short Timer
2
Short timeout between entering digits when dialing.
Range: 0 – 64 sec
Time0 3
Notes:
1. The interdigit timer values are used as defaults when dialing. The Interdigit_Long_Timer is used after
any one digit, if all valid matching sequences in the dial plan are incomplete as dialed. The
Interdigit_Short_Timer is used after any one digit, if at least one matching sequence is complete as
dialed, but more dialed digits would match other as yet incomplete sequences.
To Next Page
Loading...
