DRAFT
© 2003 - 2005 Linksys, a Division of Cisco Systems Proprietary (See Copyright Notice on Page 2)
62
Vertical Service Activation Codes
Parameter Name Description Type Default
Call Return Code Call the last caller. ActCode *69
Blind Transfer Code Blind transfer current call to the target specified
after the activation code
ActCode *98
Cfwd All Act Code Forward all calls to the target specified after the
activation code
ActCode *72
Cfwd All Deact Code Cancel call forward all ActCode *73
Cfwd Busy Act Code Forward busy calls to the target specified after
the activation code
ActCode *90
Cfwd Busy Deact Code Cancel call forward busy ActCode *91
Cfwd No Ans Act Code Forward no-answer calls to the target specified
after the activation code
ActCode *92
Cfwd No Ans Deact Code Cancel call forward no-answer ActCode *93
Call Back Act Code Callback when the last outbound call is not busy ActCode *66
Call Back Deact Code Cancel callback ActCode *86
Block CID Act Code Block CID on all outbound calls ActCode *67
Block CID Deact Code Unblock CID on all outbound calls ActCode *66
Block CID Per Call Act Code Block CID on the next outbound call ActCode *81
Block CID Per Call Deact Code Unblock CID on the next inbound call ActCode *82
Block ANC Act Code Block all anonymous calls ActCode *77
Block ANC Deact Code Unblock all anonymous calls ActCode *87
DND Act Code Enable Do Not Disturb ActCode *78
DND Deact Code Disable Do Not Disturb ActCode *79
Secure All Call Act Code Make all outbound calls secure ActCode *16
Secure No Call Act Code Make all outbound calls not secure ActCode *17
Secure One Call Act Code Make the next outbound call secure. This
operation is redundant if all outbound calls are
secure by default.
ActCode *18
Secure One Call Deact Code Make the next outbound call not secure. This
operation is redundant if all outbound calls are
not secure by default.
ActCode *19
Referral Services Codes One or more *code can be configured into this
parameter, such as *98, or *97|*98|*123, etc.
Max total length is 79 chars. This parameter
applies when the user places the current call on
hold (by Hook Flash) and is listening to 2nd dial
tone. Each *code (and the following valid target
number according to current dial plan) entered
on the 2nd dial-tone triggers the SPA to perform
a blind transfer to a target number that is
prepended by the service *code. For example,
after the user dials *98, the SPA plays a special
dial tone called the "Prompt Tone" while waiting
for the user the enter a target number (which is
checked according to dial plan as in normal
dialing). When a complete number
is entered, the SPA sends a blind REFER to
Str79
To Next Page
Loading...
