Linksys SPA941 - Page 63

DRAFT
© 2003 - 2005 Linksys, a Division of Cisco Systems Proprietary (See Copyright Notice on Page 2)
63
the holding party
with the Refer-To target equals to
*98<target_number>.
This feature allows the SPA to "hand off" a
call to an application server to perform further
processing, such as call park.
Notes:
- The *codes should not conflict with any of
the other vertical service codes internally
processed by the SPA. You can empty the
corresponding *code that you do not want to
SPA to process.
Feature Dial Services Codes One or more *code can be configured into this
parameter, such as *72, or *72|*74|*67|*82, etc.
Max total length is 79 chars. This parameter
applies when the user has a dial tone (1st or
2nd dial tone). Enter *code (and the following
target number according to current dial plan)
entered at the dial tone triggers the SPA to call
the target number prepended by the *code. For
example, after user dials *72, the SPA plays a
prompt tone awaiting the user to enter a valid
target number. When a complete number is
entered, the SPA sends a INVITE to
*72<target_number> as in a normal call. This
feature allows the proxy to process features like
call forward (*72) or BLock Caller ID (*67).
Notes:
- The *codes should not conflict with any of
the other vertical service codes internally
processed by the SPA. You can empty the
corresponding *code that you do not want to
SPA to process.
- You can add a paramter to each *code in
"Features Dial Services Codes" to indicate what
tone to play after the *code is entered, such as
*72`c`|*67`p`. Below are a list of allowed tone
parameters (note the use of back quotes
surrounding the parmeter w/o spaces)
`c` = <Cfwd Dial Tone>
`d` = <Dial Tone>
`m` = <MWI Dial Tone>
`o` = <Outside Dial Tone>
`p` = <Prompt Dial Tone>
`s` = <Second Dial Tone>
`x` = No tones are place, x is any digit not
used above
If no tone parameter is specified, the SPA plays
Prompt tone by default.
Str79