DRAFT
© 2003 - 2005 Linksys, a Division of Cisco Systems Proprietary (See Copyright Notice on Page 2)
55
Range: 0 – (2
31
– 1)
Reg Min Expires Minimum registration expiration time allowed from
the proxy in the Expires header or as a Contact
header parameter. If proxy returns something less
this value, then the minimum value is used.
Time0 1
Reg Max Expires Maximum registration expiration time allowed from
the proxy in the Min-Expires header. If value is
larger than this, then the maximum value is used
Time0 7200
Reg Retry Intvl Interval to wait before the SPA retries registration
again after encountering a failure condition during
last registration
Time0 30
Reg Retry Long
Interval
When Registration fails with a SIP response code
that does no match <Retry Reg RSC>, the SPA
will wait for the delay specified in this parameter
before retrying. If this parameter is 0, the SPA will
stop retrying. This value should be much larger
than <Reg Retry Intvl> which should not be 0.
Time0 1200
Response Status Code Handling
Parameter Name Description Type Default
SIT1 RSC
1
SIP response status code to INVITE on which to
play the SIT1 Tone
RscTmplt
SIT2 RSC
1
SIP response status code to INVITE on which to
play the SIT2 Tone
RscTmplt
SIT3 RSC
1
SIP response status code to INVITE on which to
play the SIT3 Tone
RscTmplt
SIT4 RSC
1
SIP response status code to INVITE on which to
play the SIT4 Tone
RscTmplt
Try Backup RSC SIP response status code on which to retry a
backup server for the current request
RscTmplt
Retry Reg RSC Interval to wait before the SPA retries registration
again after encountering a failure condition during
last registration
Time0 30
RTP Parameters
Parameter Name Description Type Default
RTP Port Min
2
Minimum port number for RTP transmission and
reception
Port 16384
RTP Port Max
2
Maximum port number for RTP transmission and
reception
Port 16482
RTP Packet Size Packet size in sec. Valid values must be multiple of
0.01s. Range: 0.01 – 0.16
Time3 0.03
Max RTP ICMP Err Number of successive ICMP errors allowed when
transmitting RTP packets to the peer before the
SPA will terminate the call. If value is set to 0, the
SPA will ignore the limit on ICMP errors.
Uns32 0
RTCP Tx Interval
4
Controls the interval (sec) to send out RTCP
sender report on an active connection.
Range: 0 – 255 (s)
Time0 0
To Next Page
Loading...
