23
BASIC OPERATION
Turning Transceiver ON/OFF
1.Turn the [Power] switch clockwise to turn ON the transceiver.
● A music tone sounds.
2.To turn OFF the transceiver, turn the [Power] switch
counter-clockwise.
Adjusting the Volume
Turn the [Volume] control clockwise to increase the audio
output level and counter-clockwise to decrease the audio
output level.
●If background noise is inaudible because of the squelch function,
press and hold [P3] key (the default setting is SQ OFF), then turn
[Volume] control to adjust the audio level you desire.
Frequency/Channel Selection
Press [UP] key to increase the frequency/channel, press
[DOWN] key to decrease the frequency/channel.
●You can input number directly to select the frequency and
memory channel you desired.
Transmitting
1.When ready to begin transmitting, press and hold [PTT]
switch and speak in a normal voice level.
●The TX/RX indicator on the top panel lights red and S/RF meter
shows the output power level.
●Speaking too close to the microphone, or too loudly, may
To Next Page
Loading...