41
5.Press [MENU] key to input the next character.
●The second digit blinks.
6.Repeat Step 4 and Step 5 to input up to 7 digits.
7.After inputting the 7th digit, press [F] key to finish and exit
setting mode.
●If want to amend/clear the memory channel name which you just
input, press [MENU] key when finish to input the 7
th
digit, the
cursor will move to the first digit, at this time, please operate from
Step 4.
●If want to set the next memory channel’s name, please operate
from Step 1.
8. Press [PTT] switch to exit menu system.
Channel Display Function
When this function is switched ON, the transceiver displays
only a memory channel number instead of a frequency.
1.In MR/CH/NM mode, use [UP]/[DOWN] key to select a
memory channel.
●You can’t enter this mode unless you program one memory
channel at least.
2.Press [MENU] key to access menu system.
3.Use [UP]/[DOWN] key to select to select Menu No.2 for
Band A or Menu No.3 for Band B, and press [F] key to
To Next Page
Loading...