4
PREPARATION
Charging the Battery Pack
1. Using the Battery Pack.
The battery pack is not charged at the factory, please charge
it before use. To extend the battery pack lifetime, please
power off the transceiver and remove the battery pack when
not in use and leave the battery in hot or cold place.
2. Battery Pack Characteristics.
The battery will slowly wear out even not in use. After
charging and recharging, it's normal that the talk and
standby times are noticeably shorter than normal times. If
leaving the battery in very hot place or conditions, it will
reduce the capacity and lifetime of the battery. Overcharging
may also shorten its lifetime.
3. Charging the Battery Pack.
Please charge your battery only with approved LINTON
charger. Initially charging the battery pack after purchase or
extended storage (greater than 2 months) will not bring the
battery pack to its normal operating capacity. After repeating
the charge/discharge cycle two or three times, the operating
capacity will increase to normal level.
To Next Page
Loading...