Rev: 07.03.18 Page 2
CCD-0001541
TABLE OF CONTENTS
System Information 2
Safety 2
Preparation 3
Resources Required 3
Pre-Installation 3
Installation 3
Motor and Connecting Shaft 4
Wiring the System 6
Wiring Diagram 7
Relay Control Module 7
Testing the System 8
Trolley Travel 8
Bed Lift Operation 9
Motor and Brake 9
Limit Switches - Microswitches 10
Bed Lift Control Switch - LCI-Supplied Switch Only 10
Relocating Limit Switches 11
Manual Operation 12
Manually Raise the Bed(s) 12
Manually Lower the Bed(s) 13
Always wear eye protection when performing service or maintenance to the bed lift system. Other
safety equipment to consider would be hearing protection, gloves and possibly a full face shield,
depending on the nature of the service.
Moving parts can pinch, crush or cut. Keep clear and use caution.
System Information
These ratings are for the lifting mechanism only. Attachments, such as bed platforms or sofas, are not rated
in this document. Load ratings for these items are the responsibility of the manufacturer.
• Voltage = 12V DC
• Nominal current draw = 8 amps (1 bed going up); 12 amps (2 beds going up)
• Load limit = 450 lbs dynamic (moving) load; 500 lbs static (stationary) load
Safety
Always make sure that the bed lift platform is clear of people and objects before and during
operation of the bed lift.
To Next Page
Loading...
Need help?
General
