Make sure the awning assembly is square on the unit prior to mounting the bottom 2 screws.
Extend the awning half way out by connecting the power and ground wires of the awning to a 12-18V
battery.
Secure the middle of the wall mounting channel with two #14 x 1 ½” screws (286576) at any of the three
locations shown (Fig. 5). Repeat this process for the other side of awning assembly.
Four rivets with
⁄
" grip range can be used in place of the two middle and two lower screws on laminated
walls.
At both support arms there will be a wire labeled "speakers." Connect these to the radio wires provided from
the coach (Fig. 6).
Connecting the speaker wire will be done at the same location on the support arm as the power wire for the
motor.
Speaker wire is indicated with a blue insulation on the wiring.
Replace wire covers on both support arms to secure awning power and speaker wiring.
Seal all wall penetrations to protect against water intrusion.
Solera® awnings under 21' in length DO NOT require the use of a cradle.
Securing the Fabric
Extend and retract the awning several times to ensure that the fabric is square on the roll tube.
Secure the fabric in the awning rail by installing a #6 x
½
” hex head screw through the fabric cord and fabric
1” inside the edge of the fabric on both sides.
Fig. 5 Fig. 6
Possible
screw/
rivet
locations
To Next Page
Loading...
