Lippert Components Solera Power Awning - Introduction

Solera
®
Power Awning
Introduction
The Solera
®
Power Awning features an internal motor
to steadily operate the awning. Additionally, the pitch
arm assembly allows for rain dump and adjustable pitch
features. The pitch arm assembly also provides added
stability. Additional information about this product can be
obtained from www.lci1.com/support or by downloading the
free myLCIapp. The app is available on iTunes
®
for iPhone
®
and iPad
®
and also on Google Play™ for Android™ users.
iTunes
®
, iPhone
®
and iPad
®
are registered trademarks
of Apple Inc.
Google Play™ and Android™ are trademarks
of Google Inc.
This manual provides operational procedures for the Solera
Power Awning. Operating the Solera Power Awning in any
other manner than described may result in personal injury,
damage to the recreational vehicle unit or the awning
assembly as well as voiding the Lippert Components Limited
Note: This manual will refer to the “drive side” and “idler
side” throughout for various instructions. The “drive side” is
the right hand side of the awning when facing the awning
from the exterior of the unit. The “idler side” is the left
hand side of the awning when facing the awning from the
exterior of the unit.
Prior To Installation
All screws supporting the awning assembly must have a
backer within the structure of the wall of the unit. Refer to
the unit manufacturer for proper location.
Resources Required
• Three People
• Cordless or Electric Drill or Screw Gun
• Appropriate Drive Bits
• Rivet Gun (If Needed)
• Non-Permanent Method of Marking
• Silicone Sealant or Butyl Tape
• Screwdriver
• Silicone Lubricant