Lippert Components Solera Power Awning - Installation

Solera
®
Power Awning
Installation
1. On the awning rail, mark the position of the centerlines of the support arm assemblies. Ensure that the support arm
assemblies will not interfere with any lights, vents or other obstructions.
2. Usinganon-permanentmethodofmarking,markaperpendicularlinefromtheawningraildowntotheoorline.Thisisthe
centerline of the support arm assembly (Fig.2).
3. Insert the drive head assembly shaft into the end cap
(Fig.3). Align the holes and secure with waxed screw.
Repeat process for idler head assembly at other end.
NOTE: Keep the head of the wax screw 1/8" from
fastened to avoid compromising the structural integrity of
the wax screw.
awning rail
Floor Line
Fig.2
Fig.3
awning width is from centerline to
centerline of support arm assemblies