Rev: 11.11.21 Page 11 CCD-0004203
Hanger Support - Beam Stiffener
Hanger Support Requirements (7/13/2021)
11.1
11.2 Supplement Boot Hanger 102906 for Hanger 106184 and 103713.
All toy haulers and fifth wheels must use
a hanger support plate above each hanger
(except when a crush tube is used)
Supplement boot hanger 102906 for hanger 106184 and 103713
4¼"
5¼"
3¼"
Hanger
Size/P/N
Max Weight
Rating
Use for center
hanger
Wide Stance
(34" spacing)
V-Brace
Requirements
Mount Direct
to I-beam?
2.25" (106182) None Does not work w/
all equalizers. If
you choose this
hanger, make sure
your equalizer is
compatible.
Yes w/crush tube,
no 5th wheels
None Yes
3.25" (106183) None YES Yes w/crush tube,
no 5th wheels
All triple axle setup,
TT with ≥7K axles,
5th wheel with
≥6K axles, wide
stance (34"hanger
spacing)
Yes
4.25" (106185) TT= None
5th Wheel =
11,999 lbs GVWR
YES Yes TT with 2x2
crush tube and ≥
4.4K axles, no 5th
wheels
Yes TT with = 4.4K
axles (excludes
single axle),
All 5th wheels
Yes
5.25" boot
(102906)
TT & 5th Wheel
with crush tube =
≤ 4.4K axles
Does not work w/
all equalizers. If
you choose this
hanger, make sure
your equalizer is
compatible.
N/A N/A Yes on TT with ≤
3.5K axles, but no
for 6" I-beam, no
on all 5th wheels.
Note: For tandem axles, if using different size hangers the taller hangers needs to be the center hanger.
To Next Page
Loading...
