Lippert RV - 5 th Wheel Drop Gen set up.; Drop Gen General Requirements; Drop Gen Landing Gear Support

Rev: 11.11.21 Page 19 CCD-0004203
5th Wheel Drop Gen set up.
19.1 Drop Gen must use I-beam.
19.2 Landing gear bracket must be located in drop section.
2"
Two Full Height
3" x 1.5" 7GA Angle
The Drop GEN Mains
Must Use I-Beam
Jack BRKT Must Sit on Top of Bottom
I-Beam Flange
3"
One Full Height
3" x 1.5" 7GA Angle
Full Height Plate
2" Min Overlap
19.3 If landing gear bracket is located ≤ 2" from the bottom of the front of the drop Gen, a plate and a
single jack bracket support is required as shown.
19.4 If landing gear bracket is located ≥ 2.06" from the bottom of the front of the drop Gen, two jack
brackets supports are required as shown.