Rev: 11.11.21 Page 22 CCD-0004203
Note:
1. If this is a new/special design for the customer or Lippert, it MUST be approved by management.
2. Drop front and drop rears must get management approval.
3. XMs in cargo areas on sport units need to be 24" O.C. w/a full height XM every 48".
4. Drop units must have a minimum of 24" of main rail overlap.
5. No holes in draw bars without management approval.
6. If GVWR is over 15,500 LBS., it must use HD single drive landing gear motor or dual standard motors.
7. For optimum floor/wall support, Lippert recommends aligning the XMs & ORs as much as possible.
8. ORs & XMs are required to be spaced a maximum of 48" in non cargo areas, with no more than 96"
spacing between full height XMs.
9. All formed toy hauler bumpers must be a min of 12ga material.
To Next Page
Loading...
