Lippert RV - Accepted Travel Trailer Leveling RV Engineering Guidelines - REV: (1;1;2019); Travel Trailer Leveling System Limitations

Rev: 11.11.21 Page 17 CCD-0004203
Accepted Travel Trailer Leveling RV Engineering Guidelines - REV : (1/1/2019)
17.1 Maximum GVWR 12,000 LBS for standard system; maximum GVWR 10,000 LBS for 4 C-jack system.
17.2 8" minimum I-beam height unless approved by Lippert engineering.
17.3 4 point electric leveling only.
17.4 Rear jack brackets require two web stiffeners. (Ref sec. 18.2 for mounting options.)
Front leveling jacks can be no
more than 60" max from front
head to center of jack
Rear leveling jacks should be mounted
directly across from each other but can
be offset a maximum of 14" front to rear
from each other if necessary.
Front sensor (BRAIN) plate 231775
should be mounted on bottom flange
of either FXM or the next XM back
Front sensor (BRAIN) plate
231775 should be mounted
on bottom flange of either
FXM or the next XM back
14" Outside
Maximum Spacing
240"
60"
MAX