Lippert RV - Table of Contents

Rev: 11.11.21 Page 2 CCD-0004203
TABLE OF CONTENTS
I-Beam (3/1/2021) 3
Stick and Tin 3
Stick and Tin Continued 4
Laminated Side Walls 4
Laminated Side Walls Continued 5
Crush Tube 6
Standard Crush Tubes/Riser Tubes ( 7/13/2021) 6
Crush Tubes Taller Than 2" including Extended Length Crush Tubes 6
The Extended Length Crush Tube 6
Chassis w/ Crush Tube 6
Draw Bar 7
Standard TT Draw Bar Engineering Guideline Rev. (6/15/2021) 7
Draw Bar 8
Toy Hauler TT Draw Bar Engineering Guidelines Rev: (6/15/2021) 8
Accepted Tube/I-Beam RV Engineering Guidelines Rev: (1/1/2020) 9
Outrigger 10
Engineering Guidelines Rev: (7/13/2021) 10
Hanger Support - Beam Stiener 11
Hanger Support Requirements (7/13/2021) 11
Axle Area - FHXM 12
Axle Area Full Height XMs Engineering Guidelines Rev: (1/1/2020) 12
Full Height Cross Member Requirements in the Axle Area 13
Upper Deck Main 14
Accepted Upper Deck RV Engineering Guidelines Rev: (3/1/2021) 14
Upper Deck Riser 15
Accepted Upper Deck RV Engineering Guidelines Rev: (3/1/2021) 15
Leveling 16
Accepted Leveling RV Engineering Guidelines - REV : (1/1/2020) 16
Accepted Travel Trailer Leveling RV Engineering Guidelines - REV : (1/1/2019) 17
Hydraulic Landing - Level Bracket 18
Accepted HYD Landing Gear and Leveling Bracket Supports Engineering Guidelines - REV: (3/1/2021) 18
5th Wheel Drop Gen set up. 19
Bumper Extension 20
Accepted Bumper Extension Engineering Guidelines - REV : (3/1/2021) 20
Slide-out Room Bar 21
Slide out/Room Bar Engineering Guidelines Rev: (3/1/2021) 21
Note: 22
Proprietary and Condential
The information contained in this document is the sole property of Lippert Components, Inc.
Any reproduction in parts or as a whole without the written permission of Lippert Components, Inc.
Is prohibited.