Lite-Check INSPECTOR 930 - Equipment and Setup; Required Materials

LITE-CHECK INSPECTOR 930
11
What is included with the LITE-CHECK INSPECTOR 930?
The INSPECTOR 930 ships with the following items:
1 – LITE-CHECK INSPECTOR 930
1 – Inspector 930 Operations Manual
1 – Quick Reference Guide
1 – Protective Dust Cover
1 – Remote Control
1 – Plastic Remote Cover
1 – Orange Neck Pouch For Remote
Please inspect the shipment when it arrives for any missing or damaged items.
Required Materials
The following additional materials are required to operate the INSPECTOR 930:
· 1 – 7-way cable with 7-way plugs on both ends
· 2 – 1/4” air lines with glad-hands on one end
· 2 – Quick disconnect air connectors (male and female for tester and air lines)
· 1 – Filtered air regulator to provide clean 110-120psi air pressure
Note: The above Items are available in the LITE-CHECK 302A Shop Accessory
Kit. (See LITE-CHECK INSPECTOR 930 Accessories on page 10.)
· 1 – Power supply (Either the LITE-CHECK 325S 12VDC Regulated Power Supply OR a
charged 12-volt battery.)
Note: Power to the tester must be regulated to protect the trailer’s ABS
electronics and ensure consistent tester performance.
· Mounting location or plate to secure the Inspector 930 tester.
Warning: The LITE-CHECK INSPECTOR 930 is a “diagnostic” tester that monitors the
current flow through the ground circuit to aid in identifying various fault conditions. Care
should be taken to insure that the tester’s case is not grounded to the trailer or tractor
under test. D O N O T s u p p l y t he Inspector 930 with power from the tractor when testing and
inspecting tractor/trailer combinations.
Equipment and Setup
The LITE-CHECK Inspector 930 diagnostic tester is designed for easy operation and
setup. Some additional items are required to fully utilize all of the 930’s functions.