Lite-Check INSPECTOR 930 - Power Supply; Power Supply Set Up; Low Battery Messages

LITE-CHECK INSPECTOR 930
17
· The sending lamp will light up when the button on the remote control is pressed.
Power Supply
The tester is designed for negative ground vehicles (black-negative, red-positive). In
case of reversed battery leads on the power cable, the tester will not operate.
Power Supply Set Up:
Attach the battery cable clamps (or ring terminals) to a 12VDC automotive battery, or a
regulated power supply (such as the LITE-CHECK 325S).
· Black battery cable to negative –
· Red battery cable to positive +
Turn the power switch on (located on the back panel of the tester) for operation.
Low Battery Messages
NOTE: The tester will not work properly if the battery is not charged to a full 12+volts.
The tester will not operate and will possibly lock up if the power is below 11.0 volts,
and will turn off it’s power if it’s below 9.0 volts.
Notes:
· Replace (4) AA batteries if the sending lamp does not illuminate.
· Remove the batteries using the pull strap inside the case. Do not pry them
out.
· If remote controls need to be keyed to different testers, contact LITE-CHECK
for assistance.
· The tester antenna must be fully exposed for proper signal reception.