Lite-Check INSPECTOR 930 - ABS

LITE-CHECK INSPECTOR 930
40
ABS
Press the “ABS” button on the tablet
● Reads Haldex, Bendix, Merito and Wabash ECUs with PLC through the auxiliary pin 7
● Includes support for roll stability and advanced ABS
● Displays all PLC ABS information on the tablet screen for easy access
Steps of ABS operation:
1. The Inspector will determine the condition of the BRAKE and AUXILIARY circuits
2. The Inspector will determine if a PLC signal can be detected. If there is no signal, the operator will be
notified to exit the test
3. The Inspector will determine the manufacture and ECU model
4. Additionally, it will determine the following information:
● Configuration
● Active Faults - The details for each fault can be listed. There is a help feature available for each fault (not
available for Wabash)
● Odometer reading for that particular ECU
● Trip Odometer reading, which can be reset (if supported by the ABS model)
● Serial Number for that particular ECU
● VIN if available
● ECU Voltage if available
● Wheel Speed - Displays real-time wheel speed reading as well as the highest RPM. Readings will be reset
when the test is exited
● ABS Load Test - Turns on all the lighting circuits and displays the voltage and the current at the Verifier as
well as the ECU voltage, if it is available