Loadrite Sprint - Zeroing Procedure

LOADRITE SPRINT OPERATORS MANUAL
13
Zeroing
When you raise an empty bucket past the trigger point, the display should
read zero. However, due to build up of material in the bucket, a small zero
error may occur.
Zero error affects the accuracy of lifted weights.
To Zero the Loadrite
Before lifting.
Make sure that the bucket is empty and fully
rolled back.
The loader must be on level ground.
Ready
0
Raise the bucket smoothly past the trigger
point using normal engine revs.
The Loadrite beeps and displays the load.
(Example weight 20)
Total
0
20
Press the key.
The Loadrite performs the zero adjustment
and returns to the Ready state.
Ready
0
Large Zero Error
If the weight is greater than 5% of full scale, when you press , the
Loadrite prompts Bucket Empty? If it is, press
which will zero
the empty bucket. Pressing
will not zero the scale.
If the weight is greater than 10% (typical is 10% but it can be set up to 75%
during installation) of full scale, when you press , the Loadrite
displays Too heavy, zero aborted and does not alter any settings.
This prevents any accidental zeroing of valid weights.