Loadrite Sprint - Module Error; Module Full; No Lock; Overload

LOADRITE SPRINT OPERATORS MANUAL
27
Module Error
The Loadrite has detected an error when writing to the LD941 data logger
module.
Check that the module is securely connected to the Loadrite.
Module Full
The Loadrite has detected that the LD941 data logger module is full.
The full module should be removed and taken to the MMS for data transfer.
No Lock
No Lock means that the interlock was not closed when lifting the load. The
interlock must be closed (or the bucket must be fully rolled back) while lifting
the load.
No weight is displayed and hence there is no weight to add.
Overload
Overload means that the lifted weight exceeds the full scale (capacity)
setting. If the Overload Error is set during installation, overloaded weight
cannot be added.
Overload
1.200
Overload Message
Amount overloaded
Printer Disabled
Print function has been disabled at installation.
Printer Error
The Loadrite has detected a fault in the printer.
Check that the printer is on-line and not out of paper.
Recall Disabled
Recall function does not work in ‘Static Weigh’ mode.
See page 15 for details.