Loadrite Sprint - Appendix ii Span Calibration Adjustment

LOADRITE SPRINT OPERATORS MANUAL
35
Appendix ii Span Calibration Adjustment
This function allows small changes to be made to the Loadrite calibration if
the bucket or forks of the loader are modified or if no accurate test weight is
available when the Loadrite is calibrated at installation time.
The adjustment is carried out by entering the total of weights recorded at a
weighbridge (scale house) over a period of time and the corresponding
Loadrite total.
To perform the adjustment you need to obtain a security access code from
your Loadrite installer.
WARNING The Loadrite alters its calibration every time this function is used. It is
important that you only use this function once with a given set of data. If the
same weights are entered again, the Loadrite will over correct and its
accuracy will be seriously impaired.
The method is explained below using an example.
Press .
Use   to scroll through to Setup.
Press .
Menu
Setup...
Enter the Access code supplied by your
Loadrite Dealer.
Then press .
Access
Code?
The Loadrite prompts you to enter the
Loadrite total weight.
Key in the Loadrite total and press
.
Loadrite
0
Key in the weighbridge total and press
.
WghBrdge
0